July 31, 2021

Fully automated 3D printing using REAL print beds!

Sure, there are solutions available that promise "automated" 3D printing - but they all fall short when they need to print particularly thin or warp-happy parts. So I set out to build a system that uses real magnetic beds and is able to automatically swap in a fresh one in after every print. And I'm happy to report that it works flawlessly!

Thanks to Boxomo Enclosures for sponsoring this video! Check them out at https://boxomoenclosures.com/

Some of the parts used:
Magnetic PEI beds from Energetic http://go.toms3d.org/EnergyPEI
Silicone heater http://go.toms3d.org/HotSilica
Geared stepper motor http://go.toms3d.org/NemaG
Salvaged bits from random cheap printers https://www.youtube.com/playlist?list=PLDJMid0lOOYn2zty5n3pgSQuTjFnYvUaA

Filaments used:
DAS FILAMENT B+ PETG http://go.toms3d.org/DAS
Prusament ASA (for the bed frames) http://go.toms3d.org/Prusament

Product links are affiliate links - I may earn a commission on qualifying purchases (at no extra cost to you)

🎥 All my video gear https://toms3d.org/my-gear
I use Epidemic Sound, sign up for a 30-day free trial here http://share.epidemicsound.com/MadeWithLayers

🎧 Check out the Meltzone Podcast (with CNC Kitchen)! https://www.youtube.com/channel/UCzUgJrG-w_KQexroYkJR9XQ

👐 Enjoying the videos? Support my work on Patreon! https://www.patreon.com/toms3dp

Powered by WPeMatico

linkedin facebook pinterest youtube rss twitter instagram facebook-blank rss-blank linkedin-blank pinterest youtube twitter instagram